Land Rover autosleutel repareren

Programmering van de autosleutel

Programmeren autosleutel Landrover;
Sleutel in contact 5 seconden eerste slag. daarna sleutel uit slot halen.
Gedurende 15 seconden unlock ingedrukt houden en tegelijk 3 keer de op slot zet knop indrukken. (binnen 10 seconden)
Hele procedure binnen 15 seconden afronden.
Lampje afstandbediening moet dan 7 keer knipperen.
En de auto reageert met op slot van slot af gaan.
De juiste actie om de 2e sleutel te programmeren, nadat de 1e is gelukt, is alleen binnen 30 sec. na de 1e sleutel weer van sleutel 2 de “unlock” button vasthouden en daarna 3x de “lock” button indrukken.
En klaar…….2 sleutels in sync.

Engelse tip;
Reset Procedure for your key fobs
Every signal from the remote handset contains the transmitter identification code and a rolling code. The BCU checks
the codes and only responds if the signal is from a valid transmitter. During vehicle production, the remote handsets
supplied with the vehicle are initialised to set their individual transmitter identification codes and synchronise their
respective rolling codes with the BCU. If a transmitter loses synchronisation with the BCU, or if a replacement or
additional remote handset is to be used with the vehicle, the initialisation procedure must be repeated. During the
procedure, all remote handsets for use with the vehicle must be initialised.
Initialisation Procedure
1 Ensure the vehicle is unlocked and the driver and front passenger doors are closed.
2 Install a key/remote handset in the ignition switch, then turn the ignition switch to position I and back to position
0 in less than 5 seconds to put the BCU into the initialisation mode. Continue the procedure within 30 seconds
of turning the ignition switch to position 0.
3 Remove the key/remote handset from the ignition switch.
4 Press and hold the unlock button for a maximum of 15 seconds. During this time, momentarily press the lock
button three times within 10 seconds.
5 Release both buttons.
6 Successful initialisation is indicated by the BCU locking then unlocking the vehicle. If this does not occur, repeat
step 4.
7 Repeat steps 4 and 5 with all other remote handsets belonging to the vehicle (4 maximum). Begin the
initialisation of each remote handset within 30 seconds of completing the previous initialisation, or the BCU will
drop out of the initialisation mode and the complete procedure will have to be started again.

Oplossing model 1996;
– sluit de auto
– stop de sleutel in het slot en draai naar rechts , terwijl je de afsluitknop ingedrukt houdt.
– dit een seconde of 10 vasthouden….

Mocht u vragen hebben over uw probleem, neem dan gerust contact met ons op.